Engine work
Posted: Fri Dec 19, 2025 1:30 pm
Fitted two new foam air filters to my V8 today, nice to have some clean air coming into the carbs.
Land Rover Series I, II, III Club - Forum
A place to discuss all things leaf sprung Land Rover
https://www.series123club.co.uk/forum/
Engine work
Page 1 of 2
Re: Engine work
Posted: Fri Dec 19, 2025 1:32 pm
New alternator too, this is a smaller one, so I can rotate it into the correct place when my new bracket arrives.
Re: Engine work
Posted: Fri Dec 19, 2025 1:58 pm
Hi, any chance you could post up some pics of the mods to the bulkhead? I am looking to do this in the future and keen to see how others have modded the passenger footwell?
Thanks in advance!
Thanks in advance!
Re: Engine work
Posted: Fri Dec 19, 2025 3:39 pm
Yes. Let me get some 
Re: Engine work
Posted: Fri Dec 19, 2025 4:08 pm
Here is the passenger side
Re: Engine work
Posted: Fri Dec 19, 2025 4:10 pm
Drivers side from the engine bay with engine mount picture
Re: Engine work
Posted: Fri Dec 19, 2025 4:11 pm
Drivers side bulkhead from engine
Re: Engine work
Posted: Fri Dec 19, 2025 4:11 pm
Passenger bulkhead inside
Re: Engine work
Posted: Fri Dec 19, 2025 4:12 pm
Drivers side bulkhead from inside
Re: Engine work
Posted: Fri Dec 19, 2025 4:14 pm
Sorry for posting picture by picture but was on my phone
The mats inside are standard series floor mats from britpart so you can see how much extra room is needed by the sections I have cut out.
The mats inside are standard series floor mats from britpart so you can see how much extra room is needed by the sections I have cut out.