Land Rover Series I, II, III Club - Forum

How do all, my question what at the general trim etc fastening used ?
I’ve just got hold of a replacement wiper motor cover for my series 3
The exiting fastenings are not there, l take it they are some sort of screw,Any info please.
Cheers in advance.

Section 84.15.09 of the Series 3 workshop manual shows 3 securing screws. 2 at the bottom and 1 om the top left hand side. I don't know how to post a photo.

Thanks Neil most appreciated
Found image of them in the manual, however no spec on them,
I’ve Mr googled them and I think they are 14 x 3/4 screws ref No AB614061L
Well l’ve ordered some will see if they are the right ones.